Insys WLAN Serial 11-02-01-06-02.004 ユーザーズマニュアル
製品コード
11-02-01-06-02.004
Implementation and Configuration INSYS WLAN serial
23
6.1.1.3 Status Bar
The status bar at the lower window border of the HSComm displays the settings and
activities of the serial interface.
6.1.1.4 Buttons
Read
The current settings of the INSYS WLAN serial are read and
displayed on the user interface of the HSComm WLAN.
The current settings of the INSYS WLAN serial are read and
displayed on the user interface of the HSComm WLAN.
Reset
A device reset is performed in the INSYS WLAN serial.
A device reset is performed in the INSYS WLAN serial.
Default settings
The factory settings (defaults) are loaded.
Attention! The IP address is reset as well. During a remote
configuration, this command will abort the connection.
The factory settings (defaults) are loaded.
Attention! The IP address is reset as well. During a remote
configuration, this command will abort the connection.
Send
The current settings from the HSComm WLAN user interface
are sent to the INSYS WLAN serial.
The current settings from the HSComm WLAN user interface
are sent to the INSYS WLAN serial.
Abort
Terminates a running data transmission (“Send”, “Read”, or “Default settings”). This is
indicated by the progress bar above the buttons.
Terminates a running data transmission (“Send”, “Read”, or “Default settings”). This is
indicated by the progress bar above the buttons.
RS232 Synchronize
The serial interface of the INSYS WLAN serial and the used PC must have the same
settings. With “Synchronize RS232”, all possible baud rate and data format settings at
the PC side are tested through until both sides match.
The serial interface of the INSYS WLAN serial and the used PC must have the same
settings. With “Synchronize RS232”, all possible baud rate and data format settings at
the PC side are tested through until both sides match.
6.1.1.5 Tabs
The settings for the INSYS WLAN serial and the network are spread across two pages,
which can be selected via the tab titles. The settings are transmitted to the INSYS WLAN
serial only after pressing the button “Send”.
The functions are described in detail in the following chapters.
version 1.01 / 10.04