Holzmann Maschinen H110400001 データシート
MAINTENANCE
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Seite 26
Druckluft Inverter Plasma Schneidanlage /Welder inverter plasma cutter
DIPA 40 / DIPA 100
15 MAINTENANCE
A T T E N T I O N
During cleaning and maintenance with connected machine:
Property damage and serious injury from inadvertent starting the machine!
Property damage and serious injury from inadvertent starting the machine!
Therefore:
Switch off the machine before servicing, and disconnected from the
power supply
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Check regularly that all warning and safety instructions on the machine and available in a perfect-
Check regularly that all warning and safety instructions on the machine and available in a perfect-
ly legible condition.
Check before every use the perfect condition of the safety devices as well as the saw blade!
For storage of this machine may not be stored in a humid room and must be protected from the
Check before every use the perfect condition of the safety devices as well as the saw blade!
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
Before first use, and then every 100 hours all movable connecting components (if necessary be-
Before first use, and then every 100 hours all movable connecting components (if necessary be-
fore cleaning with a brush of chips and dust) with a thin layer of oil or grease grease.
The elimination of defects does your dealer.
Repair work may only be performed by qualified personnel!
Repair work may only be performed by qualified personnel!
15.1
Cleaning
The complete and utter cleaning ensures a long life for the machine and represents a safe-
ty requirement
After each shift, the cutting torch and all parts must be thoroughly cleaned
.
N O T E
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to
the machine!
Therefore:
When cleaning, use only mild detergent
Impregnate bare surfaces of the machine against corrosion (e.g., anti-rust WD40)
15.2
maintenance
On the device there are only few of them serviceable components. It is not necessary to
disassemble the device. Repairs carried out by the specialist to perform troubleshoot-
ing