Analog Devices AD7298 Evaluation Board EVAL-AD7298SDZ EVAL-AD7298SDZ データシート

 

 

 

Rev. A | Page 1 of 16 

The EVAL-AD7298SDZ is a full-featured evaluation board 
designed to allow the user to easily evaluate all features of the 
AD7298. The evaluation board can be controlled via the SDP 
connector (J1). The SDP board allows the evaluation board to 
be controlled through the USB port of a PC using the 

evaluation software. 

On-board components include: the 

ADP1706 

low dropout CMOS 

linear regulator, the

high speed, a low noise amp, and the

 

AD8066 

high performance 145 MHz FastFET™ amp.  

The evaluation board features analog bias-up circuitry. Bipolar 
signals are input via the VIN SMB connector and are biased up 
by the on-board bias-up buffer circuit. The biased up signal is 
available at the BIASED_VIN2 SMB and can be applied to any one 
of the eight VINx SMB connectors using an SMB-to-SMB cable. 

 

Various link options are described in the Evaluation Board 
Hardware section. The Link Options section of this user guide 
should be consulted when configuring the board for standalone 
operation. 

This user guide describes the evaluation board for the 

which is a 12-bit, 8-channel successive approximation ADC with 
internal temperature sensor.  

 offers a programmable sequencer, which enables 

the selection of a preprogrammed sequence of channels for 
conversion. The device has an on-chip 2.5 V reference that can 
be disabled to allow the use of an external reference.  

 includes a high accuracy, band gap, temperature 

sensor, which is monitored and digitized by the 12-bit ADC to 
give a resolution of 0.25°C.  

Complete specifications for the 

 are provided in the 

 data sheet, available from Analog Devices, Inc., and 

should be consulted in conjunction with this user guide when 
using the evaluation board. 

 

 

 

097

1

1-

0

01