C Control PRO MINI STATION 198777 データシート
製品コード
198777
8
b) Voltage / Current Supply Clamps (Clamps +UB" and "GND")
The "+UB" connection of the upper terminal strip and the adjacent "GND" connection serve for
voltage / current supply of the "C-Control PRO Mini-Station".
The admissible supply voltage is between 9 and 16V (DC) Only use a stabilised supply voltage!
The max. current input depth is at about 200mA.
If the admissible values are exceeded, the "C-Control PRO Mini-Station" will be destroyed and
any warranty/guarantee will be void!
voltage / current supply of the "C-Control PRO Mini-Station".
The admissible supply voltage is between 9 and 16V (DC) Only use a stabilised supply voltage!
The max. current input depth is at about 200mA.
If the admissible values are exceeded, the "C-Control PRO Mini-Station" will be destroyed and
any warranty/guarantee will be void!
c) "PROG" Programming Socket
The "C-Control PRO Mini-Station" is connected to a computer by a USB programming adapter,
which is available as an accessory (Conrad Best.-Nr. 197339).
The programming socket with the name "PROG" is at the right, over the "START" button. The
sockets are protected against polarity reversal; do not use any force when connecting them.
which is available as an accessory (Conrad Best.-Nr. 197339).
The programming socket with the name "PROG" is at the right, over the "START" button. The
sockets are protected against polarity reversal; do not use any force when connecting them.
d) "STOP" and "START" Buttons
The "C-Control PRO Mini-Station" can be switched to different operational modes with buttons.
They are on the left of the circuit board, when viewing the C-Control PRO Mini-Station from the
top so that the load relays are on the right.
• STOP = C-Control PRO is in STOP mode; the programme is interrupted. "STOP" also
They are on the left of the circuit board, when viewing the C-Control PRO Mini-Station from the
top so that the load relays are on the right.
• STOP = C-Control PRO is in STOP mode; the programme is interrupted. "STOP" also
switches the station into programming mode.
• START = If you want to start or restart your programme, use the "START" button. Also press
the "START" button shortly to leave STOP mode.
e) Analogue Digital Converter ("ADC0" and "ADC1" Clamps)
The "C-Control PRO Mini-Station" has two analogue digital converters ("ADC")
A direct current (DC) of 0 to 5 V against GND (ground) can be measured at the AD converter
connections. ADC resolution is at 10Bit.
A direct current (DC) of 0 to 5 V against GND (ground) can be measured at the AD converter
connections. ADC resolution is at 10Bit.