Atmel Evaluation Kit AT91SAM9G25-EK AT91SAM9G25-EK データシート
製品コード
AT91SAM9G25-EK
379
SAM9G25 [DATASHEET]
11032C–ATARM–25-Jan-13
shows how the timing parameters are coded and their permitted range.
29.9.7 Reset Values of Timing Parameters
gives the default value of timing parameters at reset.
29.9.8 Usage Restriction
The SMC does not check the validity of the user-programmed parameters. If the sum of SETUP and PULSE parameters
is larger than the corresponding CYCLE parameter, this leads to unpredictable behavior of the SMC.
is larger than the corresponding CYCLE parameter, this leads to unpredictable behavior of the SMC.
For read operations:
Null but positive setup and hold of address and NRD and/or NCS can not be guaranteed at the memory interface
because of the propagation delay of theses signals through external logic and pads. If positive setup and hold values
must be verified, then it is strictly recommended to program non-null values so as to cover possible skews between
address, NCS and NRD signals.
because of the propagation delay of theses signals through external logic and pads. If positive setup and hold values
must be verified, then it is strictly recommended to program non-null values so as to cover possible skews between
address, NCS and NRD signals.
For write operations:
If a null hold value is programmed on NWE, the SMC can guarantee a positive hold of address, byte select lines, and
NCS signal after the rising edge of NWE. This is true for WRITE_MODE = 1 only. See
NCS signal after the rising edge of NWE. This is true for WRITE_MODE = 1 only. See
.
For read and write operations: a null value for pulse parameters is forbidden and may lead to unpredictable behavior.
In read and write cycles, the setup and hold time parameters are defined in reference to the address bus. For external
devices that require setup and hold time between NCS and NRD signals (read), or between NCS and NWE signals
(write), these setup and hold times must be converted into setup and hold times in reference to the address bus.
devices that require setup and hold time between NCS and NRD signals (read), or between NCS and NWE signals
(write), these setup and hold times must be converted into setup and hold times in reference to the address bus.
29.10 Automatic Wait States
Under certain circumstances, the SMC automatically inserts idle cycles between accesses to avoid bus contention or
operation conflict.
operation conflict.
29.10.1 Chip Select Wait States
The SMC always inserts an idle cycle between 2 transfers on separate chip selects. This idle cycle ensures that there is
no bus contention between the de-activation of one device and the activation of the next one.
no bus contention between the de-activation of one device and the activation of the next one.
During chip select wait state, all control lines are turned inactive: NBS0 to NBS3, NWR0 to NWR3, NCS[0..5], NRD lines
are all set to 1.
are all set to 1.
Table 29-4. Coding and Range of Timing Parameters
Coded Value
Number of Bits
Effective Value
Permitted Range
Coded Value
Effective Value
setup [5:0]
6
128 x setup[5] + setup[4:0]
0
≤ ≤ 31
0
≤ ≤ 128+31
pulse [6:0]
7
256 x pulse[6] + pulse[5:0]
0
≤ ≤ 63
0
≤ ≤ 256+63
cycle [8:0]
9
256 x cycle[8:7] + cycle[6:0]
0
≤ ≤ 127
0
≤ ≤ 256+127
0
≤ ≤ 512+127
0
≤ ≤ 768+127