Atmel ATSAM3S-EK2 データシート
Atmel AVR2055
49
8348D-AVR-06/12
10 Appendix A-2. megaRF specifics
10.1 Getting started
BitCloud supports two different development platforms with ATmega128RFA1:
ATRF4CE-EK
. The
instructions below will highlight the differences between the two platform
configurations, where present.
10.1.1 Required hardware
Before installing and using the BitCloud PS SDK for megaRF, make sure that all
necessary hardware is available:
•
•
For ATRF4CE-EK:
o Two or more RCB128RFA1 boards with 2.4GHz antennas and AAA
batteries
o one or more RCB breakout boards (other boards from the kit may be
used, too)
o one RS-232 interface cable for the RCB breakout board
o Atmel AVR JTAGICE mkII or Atmel JTAGICE 3
o Atmel AVR JTAGICE mkII or Atmel JTAGICE 3
•
For ATAVR128RFA1-EK1:
o Two or more ATSTK600 boards, each with an Atmega128RFA1 top
card and 2.4GHz antenna
o AVR JTAGICE mkII or Atmel JTAGICE 3
10.1.2 Hardware setup
For ATRF4CE-EK, please refer to
For STK600-ATmega128RFA1 top cards:
Figure 10-1. Jumper setting for STK600-ATmega128RFA1 top card.