Mikroelektronika MikroE Development Kits MIKROE-1377 データシート
製品コード
MIKROE-1377
8. Support
MikroElektronika off ers
Free Tech Support
(www.mikroe.com/esupport)
until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our
Libstock
website. Just download them and you are
ready to start.
ready to start.
5. IR Click™ Board Schematic
VCC
R2
2K2
LD1
C1
100nF
VCC
J1
R5
100
VCC
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
R3
2K2
Q1
BC846
R4
100K
VCC
R1
100
E1
10uF
LD2
VCC
RCV
LED
1
2
3
U1
TSOP38338
J2
J3
PWR SEL
LED
RCV
IN
RX
OUT
TX
TX
OUT
RX
IN
INPUT SEL
OUTPUT SEL
MIKROBUS DEVICE CONN.
QEE113
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specifi cation and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. SMD Jumpers
Target board microcontroller can transmit
signal to IR emitting diode via PWM (IN) or RX
as well as receive signal from IR receiver via
AN (OUT) or TX mikroBUS
signal to IR emitting diode via PWM (IN) or RX
as well as receive signal from IR receiver via
AN (OUT) or TX mikroBUS
™
pins. Jumpers J2
and J3 enable you to choose between these
two ways. J1 zero-ohm SMD jumper is used to
select between 3.3V or 5V power supply. J1
jumper is soldered in 3.3V position by default.
two ways. J1 zero-ohm SMD jumper is used to
select between 3.3V or 5V power supply. J1
jumper is soldered in 3.3V position by default.