Atmel Xplained Evaluation Board AT32UC3A3-XPLD AT32UC3A3-XPLD データシート

製品コード
AT32UC3A3-XPLD
ページ / 1021
96
32072H–AVR32–10/2012
AT32UC3A3
10. Interrupt Controller (INTC)
Rev: 1.0.1.5
10.1
Features
Autovectored low latency interrupt service with programmable priority
– 4 priority levels for regular, maskable interrupts
– One Non-Maskable Interrupt
Up to 64 groups of interrupts with up to 32 interrupt requests in each group
10.2
Overview
The INTC collects interrupt requests from the peripherals, prioritizes them, and delivers an inter-
rupt request and an autovector to the CPU. The AVR32 architecture supports 4 priority levels for
regular, maskable interrupts, and a Non-Maskable Interrupt (NMI). 
The INTC supports up to 64 groups of interrupts. Each group can have up to 32 interrupt request
lines, these lines are connected to the peripherals. Each group has an Interrupt Priority Register
(IPR) and an Interrupt Request Register (IRR). The IPRs are used to assign a priority level and
an autovector to each group, and the IRRs are used to identify the active interrupt request within
each group. If a group has only one interrupt request line, an active interrupt group uniquely
identifies the active interrupt request line, and the corresponding IRR is not needed. The INTC
also provides one Interrupt Cause Register (ICR) per priority level. These registers identify the
group that has a pending interrupt of the corresponding priority level. If several groups have a
pending interrupt of the same level, the group with the lowest number takes priority.
10.3
Block Diagram
 gives an overview of the INTC. The grey boxes represent registers that can be
accessed via the user interface. The interrupt requests from the peripherals (IREQn) and the
NMI are input on the left side of the figure. Signals to and from the CPU are on the right side of
the figure.