Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-MAXI IMX233-OLINUXINO-MAXI データシート
製品コード
IMX233-OLINUXINO-MAXI
OLIMEX© 2012
OLinuXino-MAXI user's manual
If you have a standard USB flash drive attached to a USB host, Linux and LAN running the typical
consumption is around 0.20A.
consumption is around 0.20A.
When powered by the typical 3.7V battery the LAN and USB-hosts are disabled. The consumption
when Linux is running is around 0.75A.
when Linux is running is around 0.75A.
The board can be powered either from the power jack or from the LIPO_BAT connector. Note that
since standard batteries can't provide the voltage needed for the board it is advisable to use the
power from the power jack. When you use the LIPO_BAT connector and a battery the chip handling
the Ethernet and the USB hosts is disabled. Also the power button has alternative function when the
board is powered by a battery – check 6.13.
since standard batteries can't provide the voltage needed for the board it is advisable to use the
power from the power jack. When you use the LIPO_BAT connector and a battery the chip handling
the Ethernet and the USB hosts is disabled. Also the power button has alternative function when the
board is powered by a battery – check 6.13.
If you have successfully powered the board the red PWR LED will turn on. Note that it is possible
to have the PWR LED on even if there isn't enough power for proper operation of the board and all
the peripherals currently connected.
to have the PWR LED on even if there isn't enough power for proper operation of the board and all
the peripherals currently connected.
The jumper 5V_E (5V Enable) which is closed by default enables powering the board via the power
supply circuit.
supply circuit.
Page 29 of 60