Secutech Radio modules ST002002 データシート
製品コード
ST002002
Page 26
Security & Electronic Technologies GmbH
Settings
Selection of the RF-channel block
SECU-DATA xxxx instruments use one RF-channel out of 64. These are
organized in 8 blocks with 8 channels each. The default setting is block #6.
Two SECU-DATA xxxx instruments are able to communicate only if the
same block for RF-channels is set on both instruments.
Procedure for both units:
organized in 8 blocks with 8 channels each. The default setting is block #6.
Two SECU-DATA xxxx instruments are able to communicate only if the
same block for RF-channels is set on both instruments.
Procedure for both units:
1. Open the housing of the SECU-DATA xxxx. Avoid the intrusion of
moisture and pollution while the instrument is open to maintain the
reliability
reliability
2. Turn on the power supply of the SECU-DATA xxxx
3. Press the B-button two times shortly
4.
3. Press the B-button two times shortly
4.
The green “RF“-LED will blink several times, the number of light
pulses gives the actual number of the channel block (1 to 8).
pulses gives the actual number of the channel block (1 to 8).
5. The light pulses are repeated after a 1 s pause. Each press on but-
ton A increments the block number by 1. On the end of the range
the block number falls back from 8 to 1 automatically.
the block number falls back from 8 to 1 automatically.
6. An interruption of the power supply aborts the procedure, the origi-
nal block number remains in memory; the actual one is not stored.
7. The procedure can be finished by pressing the B-button; the actual
block number is stored permanently.
8. Repeat this procedure for the second SECU-DATA xxxx to set the
same block number
If required you may check the block number using steps 1 to 4 as described
above.
above.
Button B
Button A