Reely ARF 595 mm Mini-Neptune, PNP データシート

 The flight controller is already perfectly adjusted to the motor used ex works. A change to the factory setting

therefore is not necessary for the first flight.

If the throttle lever at the transmitter is set to minimum (motor off), the flight controller automatically recognises the

position „Motor off“. This warrants a secure, fine control of the motor speed. In only a few cases (e.g. if you switch the

remote control transmitter), it may be required to re-teach the positions „full throttle“ and „motor off“. To do so proceed 

as follows:
•  Turn on the transmitter first and put the throttle lever to the position „full throttle“.
•  Connect a suitable flight battery to the flight controller.
•  After approx. two seconds, a double sound signal that is repeated four times sounds.
•  Put the throttle lever in the minimum position (motor off) at once after the first, second or third double sound sig-

nal. 

•  Another double sound signal sounds, followed by a melody. Programming is complete. The flight controller is then

ready for operation.

 If you do not put the throttle lever to the „Motor off“ position after the first three double sound sequences at

the latest, programming of the individual functions starts after the fourth double sound signal. 

 

If you do not want to perform this programming, either let all programming steps run through to the end or 

disconnect the flight battery from the speed controller.

However, the throttle lever at the transmitter still has to be in the „full throttle“ position for this! If this is not

observed, the currently active programme step may be performed unintentionally!

The flight controller can be programmed individually. Observe the information in the chapter „Notes on the Individual

Functions“ for this as well as the programming table. 
Proceed as follows for programming:
•  Turn on the transmitter first and put the throttle lever to the position „full throttle“.
•  Connect a suitable flight battery to the flight controller.
•  After approx. two seconds, a double sound signal sounds that is repeated four times.
•  After the fourth double sound signal, the flight controller switches to the programming mode after another approx.

five seconds.

•  Then all possible functions starting from „1 Brake“ to the last function „10.1 Conduct at Undervoltage“ are gone

through. Every sound sequence or melody is issued four times here before automatically switching on to the next 

programming step.