Reely remote control ARF 1550 mm Apollo-1550 データシート
製品コード
Apollo-1550
15
1. Introduction
Dear Customer,
Thank you for purchasing this product.
This product complies with the statutory national and European requirements.
To maintain this status and to ensure safe operation, you as the user must observe these operating instructions!
These operating instructions are part of this product. They contain important notes on commissioning and handling. Also consider this
if you pass on the product to any third party.
if you pass on the product to any third party.
Therefore, retain these operating instructions for reference!
All company names and product names are trademarks of their respective owners. All rights reserved.
If there are any technical questions, contact:
Tel. no.:
+49 9604 / 40 88 80
Fax. no.: +49 9604 / 40 88 48
E-mail:
E-mail:
tkb@conrad.de
Mon. to Thur. 8.00am to 4.30pm
Fri. 8.00am to 2.00pm
Fri. 8.00am to 2.00pm
2. Intended Use
This product is a model glider which is radio controlled by a remote control system to be purchased separately. The model is intended for outdoor use and should
only be flown on days with weak or no wind.
only be flown on days with weak or no wind.
The product must not become damp or wet.
The product is not suitable for children under 14 years of age.
Observe all safety information in these operating instructions. They contain important information on handling of the product.
You alone are responsible for the safe operation of the model!
3. Product Description
The flight model “Apollo DLG” is a model glider designed for thermal gliding. It can be easily controlled by model pilots who have already made initial experience
in model flight. Basic knowledge in the handling of model airplanes is absolutely required to assemble and operate this model.
in model flight. Basic knowledge in the handling of model airplanes is absolutely required to assemble and operate this model.
The flight model “Apollo DLG” is a so-called “disc launch glider” (= “DLG”), which can be brought to surprising height similar to throwing of a discus.
Of course, the flight model can also be conventionally started from the hand, at a slope or with a suitable high-start device.
The fuselage is produced in GFK technology, the wing and tail units are made of balsa wood. The wing is made in bat-rib design, the tail units of balsa boards
and the model is covered in two-coloured high-quality iron-on film.
and the model is covered in two-coloured high-quality iron-on film.
In addition to the main components mentioned above, the package includes all required rudder linkage parts, and various small parts for servo installation or
installation of the wing.
installation of the wing.
The user can control: Aileron, elevator, rudder.