Reely RtF 510 mm Bimot データシート
製品コード
Bimot
44
12. Inserting/Connecting the Flight Battery
Caution, important!
Before connecting the flight battery to the model, the transmitter must be taken into operation. Observe that
the transmitter is set to the mode desired by you and the control lever for the motor function is in the bottom
position.
Install the flight battery (1) centrally on the hook-and-loop tape in the undercarriage cut-out (2) and connect them to
the model electronics with the plug connector (3) that is protected against polarity reversal.
After approx. 2 seconds, a red LED lights up on the model electronics and signals readiness for operation of the
After approx. 2 seconds, a red LED lights up on the model electronics and signals readiness for operation of the
model. This can be controlled in the undercarriage cut-out (4).
The rudder and elevator, as well as the motor react to the movements of the control levers at the transmitter now.
The rudder and elevator, as well as the motor react to the movements of the control levers at the transmitter now.
If the LED is not lit, the transmitter may not be switched on or not recognised by the receiver (see next
chapter 13).
If the LED flashes slowly, either the control lever for the motor function is not correctly pushed to the bottom
position or the motor function trimming is set too high.
Figure 6