Reely 1:8 RC model car Nitro Buggy 518100 ユーザーズマニュアル





Even though the model and the remote control system were built according to the state of the art, there may still be
malfunctions or errors. For this reason, we would like to give you some information on how to deal with possible
problems.



• For 2.4 GHz remote control systems, the receiver must be taught to the transmitter. This process may be referred to

by the terms of „Binding“ or „Pairing“. The teaching process usually was performed by the manufacturer already;
however, it can, of course, also be done by you. Also observe the separately enclosed operating instructions for the
remote control system.

• Is the receiver battery or are the batteries/rechargeable batteries in the transmitter discharged?

• Did you switch on the transmitter first and then the receiver power supply? Always observe this order!

• Is the receiver battery connected to the corresponding connection plug correctly?

• Is the vehicle too far away? With a fully charged receiver battery and fully charged batteries/rechargeable batteries

in the transmitter, the range should be at least 50 m and more. The range can be decreased by outside influences,
such as transmitters working on the same or an adjacent frequency, proximity to metal parts, trees, etc.

The position of transmitter and receiver aerial to each other very strongly influences range. It is best when both the
transmitter and receiver aerial are vertical. If you point the transmitter aerial at the vehicle, the range will be very
short!

• Check the correct position of the servo plugs in the receiver. If the plugs are inserted rotated by 180°, the servos will

not work.

• Are the servo and speed controller plugs connected in the right orientation? If, however, the throttle/brake servo and

steering servo plugs are swapped, the throttle/brake lever controls the steering servo, and the wheel controls the
throttle/brake servo.



• The carburettor settings are incorrect. Observe that the carburettor is already correctly pre-set upon delivery; turning

the setting screws therefore is not required for initial commissioning. Only during or after the breaking in process
must carefully changes be performed. Even slightly turning of the setting screws will have large effects!

• Check the glow plug function. If the glow plug was replaced with a new one, check the glow plug type. Only a glow

plug for RC model cars must be used; see chapter 8. d). Also check the charge condition of your glow plug battery.

• Are all fuel lines OK?

• Did you fuel up on the right fuel? Only fuel for RC model cars with nitromethane/oil must be used. No function is

possible with outer fuels (e.g. petrol, 1:25-mixture, etc.).

• After extended downtime or a initial commissioning, you will have to pull the cable started rope several times for fuel

to be socket in from the tank observe the fuel line between the tank and carburettor).