Reely 1:8 RC model car Nitro Monster truck GSC2005AENGBK データシート

The manufacturer may already have inserted the glow plug in the cylinder head. In this case, check if it is screwed on 

correctly. If the glow plug is enclosed separately from the motor, it must be screwed into the opening of the cylinder 

head with a suitable glow plug key. Do not use any force for this.
Glow plugs wear, especially during the breaking-in stage. If tinder has formed on the glow coil, there may be problems 

with starting or operation.
Therefore, we recommend that you always keep some glow plugs at hand for replacement. There are glow plugs with 

different heat values.
Use glow plugs for RC cars only! The wrong glow plug, e.g. for a 4-cycle plane engine, will cause the engine to run 

incorrectly and impairs reconciliation.
Generally, the following rule applies: The higher the nitromethane share in the fuel, the „colder“ the glow plug should 

be. This also applies the higher the ambience temperature when driving.
A „hot“ plug must be used at low nitromethane ratios (e.g. for breaking in the motor) or low outdoor temperatures.

The air filter comprising of a foam ring (A) at the carbu-

rettor of the vehicle must be oiled with suitable air filter oil

before commissioning of the vehicle.
The foam ring can be removed by turning out the screw 

(B) and removing the holding lid.
The oil in the air filter ensures that finest dust particles

stick to the oil and do not get into the motor. 
These  fine  dust  particles  increase  wear  at  the  pistons

and cylinder wall and reduce output. At continuous motor 

operation without oiled air filter, permanent motor damage

may occur; loss of warranty/guarantee!
Check the air filter for correct oiling before every run. Oil it with a special air filter oil (not included in the delivery,

available as an accessory) only. Never drive without an oiled air filter!
For oiling, push the air filter (only the foam ring) into a small plastic bag and add a few drops of air filter oil. Close the

plastic bag and compress the air filter several times so that the air filter oil moistens the entire air filter.
Wash the air filter from time to time (depending on dust load when driving after each drive if necessary) with benzene

or replace it with a new one.