Reely 4WD RtR 2.4 GHz E16RTBL データシート

The car body is attached to the car with 4 clips. Pull them out and take off the car body upwards carefully.

Now remove the car body. Remove the car body splints 

and take off the body upwards. 
Guide the aerial cable through the enclosed aerial tube 

(1) and plug it into the respective holder (2) at the top of 

the vehicle.
For a wide range, the aerial needs to protrude from the 

vehicle as vertically as possible.
Never coil the aerial cable! This greatly reduces the ran-

ge.
Ensure that the aerial cable is not damaged. Never shor-

ten the aerial cable!
If the car body has no hole for the aerial, the hole can be made with a 5 mm drill at the corresponding location of the 

car body (if required, pre-drill with a small drill first).

Open the transmitter’s battery compartment and insert either batteries or fully charged rechargeable batteries. Obser-

ve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again. 
Observe the enclosed operating instructions for the remote control system.

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions. If the trans-

mitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.