Reely Brushless 1:10 RC model car Electric Shor RH1019 ユーザーズマニュアル





Remove the safety clips of the car body carefully and then lift it from the chassis.

There is a transparent dust protection cover below the car body. It is also attached to the chassis with safety clips.

If the aerial cable does not protrude from the receiver boy,
loosen the two screw of the receiver box lid forest.

Guide the aerial cable through the opening in the lid.

Wrap the receiver, e.g. with a little foam to protect it from
vibration.

Re-attach the lid and screw it tight.

Push the aerial cable through the aerial tube and plug it into
the corresponding holder in the lid of the receiver box; see
arrow on the right.

Never shorten the aerial cable; this reduces the range
extremely!

Open the transmitter’s battery compartment and insert either batteries or fully charged rechargeable batteries. Observe
correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.

Observe the enclosed operating instructions for the remote control system.

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.

If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.

Observe the enclosed operating instructions for the remote control system.

§