Reely Brushless 1:10 RC model car Electric Shor RH1019 ユーザーズマニュアル





Before cleaning or servicing, turn the speed controller off and completely disconnect the drive battery from
the speed controller. If you have driven the vehicle before, let all parts (e.g. motor, speed controller, etc.) cool
down completely first.

Clean the whole vehicle of dust and dirt after driving, e.g. with a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.

Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and
lead to discolouration of the plastic parts.

Never wash the vehicle with water, e.g. using a high-pressure cleaner. This will destroy the engine, speed
controller and receiver. The vehicle must not become damp or wet!

At appropriate intervals, you should perform maintenance work and function checks on the vehicle. This
ensures trouble-free operation and road-worthiness for a long time.

Motor vibrations and shocks during driving can loosen parts and screw fittings.

• The tight fit of wheel nuts and of all vehicle screw fittings

• Fastening of speed controller and receiver

• Glue-connections of tyres and rums or tyre condition

• Attachment of all cables (they must not get into movable parts of the vehicle)

Also check the model for damage before each use. If you find any damage, the car may not be used anymore
and has to be taken out of operation.

Only original spare parts must be used to replace worn vehicle parts (e.g. tyres) or defective vehicle parts
(e.g. a broken transverse link).

The distance between the motor pinion and main gear must be as low as possible without the gears being too tight.

How to achieve this?

Loosen the two motor attachment screws slightly. Then push the motor with the motor pinion in the direction of the
main gear with light pressure.

The motor pinion and the main pinion now engage without clearance. However, this is not perfect for the service life of
the gears!

Put a thin paper strip (no more than 80 g paper!) between the motor pinion and the main pinion. Then manually turn
the main pinion so that the paper strip is pulled in between the two pinions.
The pressure of the paper pushes back the motor by the required measure.

Now tighten the motor’s attachment screws again in this position.