Reely 1:10 RC model car Electric Monster truck FS-53801-6 ユーザーズマニュアル

Screw two control arm holders to the front part of the chassis plate.
Use four M3x12 countersunk screws and four small M3 stop nuts.

The control arms are labelled "A" and "B" (see circle in the illustration
on the right).

Make sure the alignment is correct when tightening the screws. Check
the correct position. The holes in the chassis plate for the installation
of the differential must be accessible. They must not be covered.

Attach the front differential using four countersunk tapping screws.

Proceed in the same way to install the rear control arm holders.

Observe the engraved marking and install the control arm holder as
illustrated on the right.

Before screwing tight the rear differential, insert the cardan shaft
between the two differentials.

Only now may the rear differential be attached to the chassis using
four countersunk tapping screws.

If necessary, reposition the motor on the motor holder so that the dif-
ferential can be inserted. Pay attention to the position of the ball bearing
of the drive shaft in the motor holder.

Now adjust the distance between the motor pinion and the main gear
wheel. See chapter 7. e).