Reely 4WD ARR QCO1E4W000EV60N01 データシート

Then one holding bracket (B) must be attached
to the T-shaped holder with two screws. The fig-
ure on the right shows the procedure for the rear
axle again.

Last, the car body rods (C) adjustable in height
must be inserted in the holding bracket.

Make sure that the rounded end of the car body
rod points up.

Place the car body holder (D) on the two car body
rods (C).

Screw the car body holder (D) to the two car body
rods (C).

Set the two car body rods depending on the car
body used. Then fasten the car body rods in the
holding bracket (B) with one screw each.

Last, cut off the car body rods at the bottom. En-
sure that the car body rods can still be sufficiently
adjusted - do not cut them off too short.

Drill holes in the car body for the care body holder (D). A so-called car body drill is a suitable tool for this.

Metal clips for fastening the car body to the car body holder (D) are included with the vehicle.

If you have not done so yet, insert batteries or fully charged rechargeable batteries into your transmitter. Observe the
operating instructions for the remote control system used by you.

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.

If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection. Please also note the
operating instructions of the remote control system.