Reely Brushless 1:8 RC model car Electric Monst QCO08E4W8082109R01 ユーザーズマニュアル

Le déport de roue se règle en tournant la vis
(A) du bras transversal supérieur.

Comme la vis a un filetage à gauche et à droite,
vous ne devez pas démonter le bras transver-
sal pour régler le déport de roue.

La fusée d’essieu comporte plusieurs autres
points de suspension (B) pour le bras trans-
versal supérieur. En cas de débattement
intérieur ou extérieur des roues, le déport de
roue varie en fonction de la position de montage
(par ex. déport de roue accru en cas de
débattement intérieur de la roue).

If the neutral position is not correct (e.g. trimming control slightly off), you cannot switch between forward
and reverse driving. If you have this problem, correct the trimming for the driving function or perform speed
controller programming (see chapter 10. a).

Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all.

This behaviour could be caused by low drive batteries, low batteries/rechargeable batteries in the remote
control or by too great a distance between vehicle and remote control.

An aerial which is not fully extended, disturbances on the radio channel used (e.g. other models, radio
transmissions through other devices) or adverse transmission/reception conditions could also be a cause
for unusual responses of the vehicle.

Since the receiver is supplied with power through the speed controller BEC and thus through the drive
battery, low or empty drive batteries will cause unintentional movement of the vehicle (e.g. twitching of the
steering servo, etc.). For example, the voltage of the drive battery decreases for a short time under full
throttle, so that the receiver will no longer receive the required operating voltage. The vehicle will speed
up, but the steering servo does not react properly. Stop operating the vehicle at once and use a new, fully
charged drive battery (or, when using the Y-cable, two fully charged drive batteries).

Before the next drive, wait for at least 5 - 10 minutes until motor and speed controller have cooled down
sufficiently.

• Let go of the throttle/brake lever on the transmitter so that it goes into neutral position, and let the vehicle run out.

• When the vehicle has stopped, take off the body and turn off the speed controller.

Never touch the wheels or the drive mechanism, and make sure you do not move the throttle/brake lever
at the transmitter! Do not hold the vehicle at its wheels!

• Disconnect the drive battery or batteries from the speed controller. Disconnect the connections completely.

• It is only now that the transmitter may be turned off.

The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!