Reely RC model helicopter RtF 150 1195426 データシート

Move the control stick for the pitch and tail functions (also see 

figure  1,  item  17)  to  the  bottom  position  and  switch  on  the

transmitter. Observe the correct position of the toggle switches 

„Flight Mode“ and „Throttle hold“.
Then connect the plug of the helicopter connection cable (1) 

that is protected against polarity reversal to the plug connector 

of the flight battery (2). Observe that the connection cables do

not drag at the main pinion (3) and are not damaged.
Right behind the battery connection, the LED under the canopy 

(see figure 20, item 6) of the helicopter lights up and the elect-

ronics in the model perform a reconciliation. If the LED flashes

slowly, the helicopter is not receiving a remote control signal.
After approx. 4 seconds, the swash plate (4) moves up and 

down  briefly  twice  to  signal  successful  reconciliation  of  the

electronics and binding of the helicopter to the transmitter.
The swash plate should now be aligned perfectly horizontally 

(see auxiliary line in the lower figure).
Now your model helicopter is ready to start.

  If the swash plate is slightly tilted, use the trim or twist the linkage rods to adjust the swash plate precisely. 

For further information on this, see the following chapters „Trimming the Model Helicopter“ and „Fine-Tuning 

the Model Helicopter“.