Reely RC model helicopter RtF 150 1195426 データシート

If the nod or roll trim must be adjusted a lot for the helicopter to hover stably, you can also mechanically adjust the 

swash plate linkage. For this, it is sensible to remove the canopy.
Before you adjust the rods, check if the basic trim may be set incorrectly. For more information, see chapter 14 c).
Generally observe that the helicopter always flies in the direction into which the swash plate is tipped or tilted. If the

helicopter tries to fly to the left, the linkage must be adjusted until the swash plate is tipped farther to the right. If the

helicopter tries to fly forward, the linkage must be adjusted until the swash plate is tipped farther to the rear.
Lift the canopy (1) off of the support bolts (2) on the left and the 

right and pull the canopy off forwards.
If the swash plate is slightly askew so that the helicopter keeps 

flying in one direction, disconnect the ball sockets (3) of the

linkage rods (4) from the swash plate arms (5) and twist them 

to set the required rod length.
Unhooking  and  hooking  in  the  ball  sockets  is  easiest  when 

using small tweezers or thin long nose pliers. Work with the 

required care to avoid damage to the swash plate linkage or 

breaking off parts.

Always disconnect the flight battery from the model

before carrying out any maintenance or adjustment 

works at the mechanics.

Set the linkage rods so that the model helicopter hovers stably 

without any large adjustments of the nod and roll trim and the 

basic trim out of the centre position being required.