Reely RC model sailing boat ARR 800 mm Tri800 データシート
製品コード
Tri800
36
9. Operating the Model
a) Inspecting the Control Functions
After switching on the transmitter and pushing the on/off switch in the model, your model is ready for operation.
The sail winch should not start up or hum at this moment.
The sail winch should not start up or hum at this moment.
Figure 13
Check the rudder linkage.
Operate the steering lever for steering (figure 13, two upper image series). Steering to the left must cause the rudder
(viewed from behind in driving direction) to swivel to the left as well.
(viewed from behind in driving direction) to swivel to the left as well.
If this is not the case, you need to select the steering servo reverse function at the transmitter (see operating instructions
of the remote control).
of the remote control).
If the steering wheel for the steering function at the transmitter as well as the trimming for it are in the neutral position,
the rudder must be placed centrally.
the rudder must be placed centrally.
Otherwise, the trimming at the transmitter must be adjusted accordingly (see operating instructions of the remote
control).
control).
Alternatively, or if transmitter trimming is no longer sufficient, you need to readjust the linkage with the control wheel in
the neutral position and neutral trimming by loosening the screws at the rudder linkage lever (figure 1, item 3).
the neutral position and neutral trimming by loosening the screws at the rudder linkage lever (figure 1, item 3).