3D Systems Cube 381000 データシート

34

If you are not connected to a network, you can download your creations from your computer and save them to your USB memory 
stick for printing.

‡

:KHQSULQWLQJZLWKWKH86%PHPRU\VWLFNWKH¿OHPXVWEHLQWKHPDLQIROGHUORFDWHGRQWKHPHPRU\VWLFN,ILWLVSXWLQWR
another folder it cannot be accessed from Cube screen.

‡

Install your USB memory stick into your computer’s USB connection and save your creation to your USB memory stick.

‡

When you are ready to print your creation, install your memory stick into the Cube’s USB connection and print your cre-

ations. 

2.  If your USB memory stick is connected to the Cube, please remove the memory stick, (the screen will display the directions 

to do this). Tap the “NEXT” arrow on the display;  locate the USB cable and connect the cable to the Cube USB port located 
on the back of the Cube (again, these instructions will be displayed on the screen). Connect the other end of cable to your 
computer’s USB port. 

127(1HYHUOHDYHWKH86%FDEOHFRQQHFWHGH[FHSWZKHQXSJUDGLQJWKH¿UPZDUH

3.   Tap the “NEXT” arrow.  “SETTINGS SAVED” will be displayed at the top of the screen.  You will have 6 seconds to press 

DQGKROGWKHFRQWUROEXWWRQXQWLO¿UPZDUHORDGHUDSSHDUVRQWKHVFUHHQ,IWKHEXWWRQLVUHOHDVHGEHIRUHWKH¿UPZDUHVFUHHQ
DSSHDUVWKHVFUHHQZLOOJREODQN5HSHDW³6WHS´WRUHVWDUWWKHXSGDWH¿UPZDUHSURFHVV

1.  Tap on “Setup” on the Cube touch screen and scroll to “Update Firmware.” Finger tap “Update Firmware.”