German RepRap 100310 データシート
NEO 3D-Printer Quick guide
Seite:
24/30
Stand:
2014/06/07 23:06
© German RepRap GmbH
24/30
Humidity, solar radiation, heat, open fire
Protect the device from extreme humidity, dripping and splash water (do not place any liquid-filled
containers such as beverages on it). Do not place the device near a heater, do not expose it to
extended direct sunlight and do not operate it in damp rooms. Only use the device in a moderate, not
a tropical climate. Do not put any open flames such as candles on the device!
containers such as beverages on it). Do not place the device near a heater, do not expose it to
extended direct sunlight and do not operate it in damp rooms. Only use the device in a moderate, not
a tropical climate. Do not put any open flames such as candles on the device!
Ventilation
The heat arising in the device is sufficiently discharged. Nevertheless do not install the device in a
closet or in a shelf with insufficient ventilation. Never cover the ventilation slots of the device, if there
are any.
closet or in a shelf with insufficient ventilation. Never cover the ventilation slots of the device, if there
are any.
Do not place any object on the device. To allow heat to dissipate, please allow at least 30cm above,
20cm to each side and 30cm behind the device unobstructed.
20cm to each side and 30cm behind the device unobstructed.
The device only complies the declaration of conformity if the transparent case is assembled and the
door closed while operating.
door closed while operating.
Long absence, thunderstorms, accessibility of the power
plug
plug
To completely disconnect the device from mains power just pull the power plug out of the mains
socket. Make sure this socket is accessible. In case of longer absence and possible thunderstorms,
switch off the device with the power switch and then disconnect it from the mains. This also applies
for USB appliances connected to the device.
socket. Make sure this socket is accessible. In case of longer absence and possible thunderstorms,
switch off the device with the power switch and then disconnect it from the mains. This also applies
for USB appliances connected to the device.
Installation site
Every electronic device develops heat. The heating of the device is within the permitted range though.
Sensitive surfaces may discolor over time due to heat exposure. Moreover, the rubber feet of the
device may cause color changes on furniture surfaces. If applicable, please place the device on a solid,
appropriate and plane base!
Sensitive surfaces may discolor over time due to heat exposure. Moreover, the rubber feet of the
device may cause color changes on furniture surfaces. If applicable, please place the device on a solid,
appropriate and plane base!
Please mind the practicability when choosing the installation site (sufficient working height).