3D Systems CubeX CUBEX データシート

40

5.  Material will then be drawn into the print jet until a small amount of material comes out of the heated print tip on the bottom 

of the print jet.  Remove the jetted material being careful not to touch “

HOT

” print tip. Dispose of jetted material; press Next.

6.  Insert Cube tube (clear tube) into print jet and press Next; loading of the cartridge is completed. If the first attempt at

loading the cartridge is not successful because the material did not jet from the print tip, remove the material from the 

print jet. Repeat the Material Cartridge Installation.