Renkforce 3D printer assembly kit RF1000 Single extruder (value.974113) RF1000 データシート

(1)  Select the serial port to which your printer is connected.

 The port number is system-dependent. You can find it in the device manager of the control panel, under connections

(COM and LPT).

(2)  Set the baud rate as shown.
(3)  Click “OK” to save the changes.

(1)  Click “File”.
(2)  Select “Open Profile”.

Select a filament configuration file for the filament used by you in the selection window and confirm your selection.

 You can find the configuration file “Settings.ini” on the enclosed SD card in the folder “Cura”. Alternatively, you can skip

this step. The software then uses its own basic settings that are sufficient for the first print.