Siemens SPS starter kit 6ED1057-3BA10-0AA8 6ED1057-3BA10-0AA8 データシート
製品コード
6ED1057-3BA10-0AA8
User interface
2.8 Menu bar
LOGO!Soft Comfort Online Help
Operating Instructions, 06/2014
Operating Instructions, 06/2014
97
While simulation mode is active, you can also right-click a digital input in the circuit program
and edit its block properties. In the Simulation tab of the block properties dialog, you can
select the type of the input as described above.
Click "OK" to confirm your settings.
Click "OK" to confirm your settings.
2.8.5.25
Tools -> Connect Modem
You can build network connections between LOGO!Soft Comfort and LOGO! devices to
download and upload circuit programs or network projects by configuring their connected
modems. LOGO!Soft Comfort supports 11-bit modems that use standard AT commands.
Select the Tools → Connect Modem menu command to start the process of configuring
modems connected to your PC with LOGO!Soft Comfort. The LOGO! Base Module at the
remote side is also connected with a modem and ready for network connection. LOGO!Soft
Comfort displays a Modem Information dialog that provides an overview of the configuration
process.
You must complete a series of dialogs to configure your modems. After you configure the
You must complete a series of dialogs to configure your modems. After you configure the
modems and make the connections, you can download and upload circuit programs or
network projects between LOGO!Soft Comfort and LOGO! Base Module across a telephone
line connection over the modems.
The steps for connecting and configuring modems are listed below:
1. Select Modem (Page 98)
2. Select Remote Configuration (Page 98)
3. Configure Remote Modem Command (Page 98)
4. Configure Remote Modem (Page 98)
5. Select Local Configuration (Page 99)
6. Configure Local Modem Command (Page 99)
7. Configure Telephone Number (Page 99)
From the modem configuration dialogs, you can click "Next" to proceed through the dialogs,
The steps for connecting and configuring modems are listed below:
1. Select Modem (Page 98)
2. Select Remote Configuration (Page 98)
3. Configure Remote Modem Command (Page 98)
4. Configure Remote Modem (Page 98)
5. Select Local Configuration (Page 99)
6. Configure Local Modem Command (Page 99)
7. Configure Telephone Number (Page 99)
From the modem configuration dialogs, you can click "Next" to proceed through the dialogs,
or click "Previous" to return to an earlier step.
Note
This menu command is valid only for LOGO! devices series 0BA6 or later.
This menu command is valid only for LOGO! devices series 0BA6 or later.