Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 データシート
製品コード
6ED1057-3BA00-0AA8
User interface
2.7 Toolbars
LOGO!Soft Comfort Online Help
Operating Instructions, 06/2014
Operating Instructions, 06/2014
41
Note
When converting between LAD and FBD, the total number of blocks in your circuit program
When converting between LAD and FBD, the total number of blocks in your circuit program
can sometimes increase. This could cause the permitted number of blocks for your LOGO! to
be exceeded.
You cannot, therefore, always convert FBD programs to LAD.
Remedy: Under Tools -> Select Hardware (Page 90), select the hardware series that you are
You cannot, therefore, always convert FBD programs to LAD.
Remedy: Under Tools -> Select Hardware (Page 90), select the hardware series that you are
using. Start converting to LAD. Then under Tools -> Determine LOGO! (Page 90), see which
hardware series is compatible with the circuit program.
If your circuit diagram contains a UDF block, you cannot use this function to convert it from
If your circuit diagram contains a UDF block, you cannot use this function to convert it from
FBD to LAD.
See also
Tools -> Select Hardware (Page 90)
2.7.3.7
Online test
The online test and simulation (Page 95) modes allow you to monitor the execution of your
circuit program and how it reacts to the various input states.
Difference from simulation mode
In simulation mode you execute your circuit program on the PC. To do so, you do not require
a LOGO!. You can preset the status of inputs on the PC.
During an online test, LOGO! executes the circuit program and you can monitor this "work"
During an online test, LOGO! executes the circuit program and you can monitor this "work"
of LOGO!. The status of the inputs corresponds with the actual states at LOGO! inputs.
Prerequisite for an online test
You must link your PC to a LOGO!. LOGO!Soft Comfort uses the interface you specified in
Tools → Transfer (Page 70) to link to LOGO!.
You can test a circuit program in either FBD or LAD format and you must transfer it to
You can test a circuit program in either FBD or LAD format and you must transfer it to
LOGO! for the online test.
The circuit programs in LOGO!Soft Comfort and on LOGO! must be identical. Upload the
The circuit programs in LOGO!Soft Comfort and on LOGO! must be identical. Upload the
program from LOGO! to your PC, or download the program from your PC to LOGO! if
necessary.
You can monitor the parameters of up to 30 blocks. The number of blocks you can monitor
You can monitor the parameters of up to 30 blocks. The number of blocks you can monitor
simultaneously decreases when you monitor blocks that contain a high number of
parameters (for example, analog SFBs).