HP 951XL Officejet Value Pack-75 sht/A4/210 x 297 mm CR712AE#ABH データシート
製品コード
CR712AE#ABH
Carcinogenicity
None of the components present in this formulation at concentrations equal to or greater than
0.1% are listed by EU, MAK, IARC, NTP or OSHA.
0.1% are listed by EU, MAK, IARC, NTP or OSHA.
Classification
Not classified.
Physical hazards
Not classified as a physical hazard.
Health hazards
Not classified as a health hazard.
Environmental hazards
Not classified as an environmental hazard.
Components
CAS #
Percent
EC-No.
Classification
3. COMPOSITION/INFORMATION ON INGREDIENTS
616-45-5
5 - 7.5
2-pyrrolidone
Xi;R36/38
210-483-1
Proprietary
2.5 - 5
Aliphatic diol
Proprietary
112-60-7
2.5 - 5
Tetraethylene glycol
Xi;R36/37/38
203-989-9
7732-18-5
> 65
Water
231-791-2
Composition comments
This ink supply contains an aqueous ink formulation.
This product has been evaluated using criteria specified in the EU Directives 67/548/EEC and
1999/45/EC, as amended.
For the full text of the R phrases mentioned in this Section, see Section 16.
This product has been evaluated using criteria specified in the EU Directives 67/548/EEC and
1999/45/EC, as amended.
For the full text of the R phrases mentioned in this Section, see Section 16.
4. FIRST AID MEASURES
Inhalation
Move to fresh air. If symptoms persist, get medical attention.
Skin contact
Wash affected areas thoroughly with mild soap and water. If irritation persists get medical
attention.
attention.
Eye contact
Do not rub eyes. Immediately flush with large amounts of clean, warm water (low pressure) for at
least 15 minutes or until particles are removed. If irritation persists get medical attention.
least 15 minutes or until particles are removed. If irritation persists get medical attention.
Ingestion
If ingestion of a large amount does occur, seek medical attention.
5. FIRE-FIGHTING MEASURES
Flash point
> 100 °C (> 212 °F) Pensky-Martens Closed Cup US EPA Method 1020
Suitable extinguishing media
For small (incipient) fires, use media such as foam, sand, dry chemical, or carbon dioxide.
For large fires use very large (flooding) quantities of water and/or foam, applied as a mist or spray.
For large fires use very large (flooding) quantities of water and/or foam, applied as a mist or spray.
Extinguishing media which
must not be used for safety
reasons
must not be used for safety
reasons
None known.
Unusual fire & explosion
hazards
hazards
None known.
Specific methods
None established.
Hazardous combustion
products
products
Refer to section 10.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions
Wear appropriate personal protective equipment.
Environmental precautions
Do not let product enter drains. Do not flush into surface water or sanitary sewer system.
Other information
Soak up with inert absorbent material. Slowly vacuum or sweep the material into a bag or other
sealed container. Dispose of in compliance with federal, state, and local regulations. See also
section 13 Disposal considerations.
sealed container. Dispose of in compliance with federal, state, and local regulations. See also
section 13 Disposal considerations.
7. HANDLING AND STORAGE
Handling
Avoid contact with skin, eyes and clothing.
Storage
Keep away from excessive heat or cold. Keep out of the reach of children.
Germany
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure limit values
Components
Type
Value
Tetraethylene glycol (112-60-7)
1000.0000
mg/m3
mg/m3
TWA
Additional exposure data
Exposure limits have not been established for this product.
Exposure controls
Use in a well ventilated area.
Material name: CN046Series
12092 Version #: 01 Revision date: 06-Dec-2011 Print Date: 06-Jan-2012
SDS GERMANY
2 / 5