Kingston Laptop RAM () DDR3 RAM 204-pin SO-DIMM KVR13S9S6/2 データシート
製品コード
KVR13S9S6/2
KVR13S9S6/2
2GB 1Rx16 256M x 64-Bit PC3-10600
CL9 204-Pin SODIMM
CL9 204-Pin SODIMM
DESCRIPTION
This document describes ValueRAM's 256M x 64-bit (2GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM) 1Rx16, memory
module, based on four 256M x 16-bit FBGA components. The
SPD is programmed to JEDEC standard latency DDR3-1333
timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold
contact fingers. The electrical and mechanical specifications
are as follows:
FEATURES
•
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•
VDDQ = 1.5V (1.425V ~ 1.575V)
•
667MHz fCK for 1333Mb/sec/pin
•
8 independent internal bank
•
Programmable CAS Latency: 9, 8, 7, 6, 5
•
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•
8-bit pre-fetch
•
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•
Bi-directional Differential Data Strobe
•
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•
On Die Termination using ODT pin
•
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•
Asynchronous Reset
•
PCB : Height 1.180” (30.00mm), single sided component
Document No. VALUERAM1371-001.A00 11/12/13 Page 1
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD)
9 cycles
Row Cycle Time (tRCmin)
49.125ns (min.)
Refresh to Active/Refresh
260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)
36ns (min.)
Maximum Operating Power
1.050 W*
UL Rating
94 V - 0
Operating Temperature
0
o
C to 85
o
C
Storage Temperature
-55
o
C to +100
o
C
*Power will vary depending on the SDRAM used.
Continued >>