Renkforce 3D printer assembly kit RF1000 Single extruder (value.974113) RF1000 データシート

The graphics window may be switched to display temperature curves. There, the temperatures and their course are graphically

displayed in a chart.

During the first centimetres of printing, the distance between the heating plate and extruder can be manually adjusted with the

buttons for heating plate movement (3).
It should be approx. 0.2 mm (corresponds to about twice the paper thickness of regular 80g/m² printer paper).

 The distance between the extruder and heating plate is later set precisely with the software but the manual setting is

sufficient for the first print.

If no filament escapes from the extruder at first, the filament infeed button (4) must be pushed until filament escapes.

 At PLA printing of small objects with a small footprint, it is recommended to apply the heating plate with cleaning tape or

a slightly structured crepe tape before printing. Spraying the heating plate with hair spray can be helpful here as well.

These measures increase adhesion of the printed object on the heating plate.

Let the printed object cool off for a few minutes after printing. When the temperature of the heating plate is below 40 °C (see dis-

play), the printed object comes free from the heating plate and you can remove it.
If the printed object does not come loose easily, you can loosen it carefully with a painter’s spatula, knife, etc.