DVS 99000153 ユーザーズマニュアル

  Blower, DVS Gas 

(Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance)

Part # 99000153

Page 1 of 4

4070219

Upon receipt of this kit, check the condition of the packaging.  Damage to the package should be noted on the carrier's freight
receipt.  Any damage claims as a result of shipping must be handled through the shipper.  Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package.  Please report any missing items immediately.

• Lopi Berkshire                • Tree of Life          • Avalon Prairie         • Avalon Cedar         • Lopi Allegiance (2001 model)

• 11/32” Socket Wrench          • 1/4” Nutdriver          • 1/2” Open End Wrench

• Blower Assembly          • Wiring Harness         • Thermodisk         • Two Rubber Grommets (with spacers)

• Two Nuts and Washers         • Stud Plate          • Rheostat (with attachment nut & lock washer)        • Rheostat Knob

Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.

Attach the two black wires on the included wiring harness to the thermodisk (orientation does not matter).  Then slide
the thermodisk into the holder underneath the burner pan at the right rear of the stove.

Snap Disk Bracket 

(attached to stove)

Snap Disk

Snap Disk Wires on Wiring Harness

(Black - orientation does not matter)

Back of 

Stove

Snap Disk Wires

(Black - orientation 

does not matter)

Back of Stove

Remove the snap disk cover plate below 

the burner on the left side (when facing 
the stove from the front).

Attach the snap disk 

using the screws 
removed in step "a".

Attach the wires 

labeled snap disk  to 
the snap disk.