Eaton Electrical PROFIBUS-DP EZ204-DP ユーザーズマニュアル

For more information visit: www.EatonElectrical.com

MN05013001E

When this module is selected, the master only sends 1 byte 

(coil output data S1 to S8) via PROFIBUS.

Requirement:

The “Outputs; 1 byte” module must have been selected. 

The 1 byte modules are not available in all device 

combinations. If any problems occur in handling, first check 

the state of the GW message in the status display of the basic 

unit:

0

Status of R1 to R8

J

Table 5 on Page 41

J

The input data and control commands can now only be 

used if you have selected the appropriate modules as well.

GW static:

The 1-byte mode can be used

GW flashing:

Check the device version of the EZ204-

DP and the basic unit. If these are valid, 

check the configuration in the PROFIBUS 

network and the Configurator.