Oasis Concepts PHT1AQK ユーザーズマニュアル

Do not install feed water assembly on the hot water line.
Before installation, read the instructions on the outside of
the packaging.

The drain clamp assembly should be installed on a
straight length of drainpipe between the “P” or “S”
trap and the sink.  If possible, orient the hole to be
drilled toward the desired location of the drinking
water faucet.  Installation should be as far away as
practical from the garbage disposal.  If you have a
double sink, install drain outlet on the sink drain
opposite disposal.

1)  Position drain outlet saddle on drainpipe.  Allow

adequate space for drilling operation.

2)   Tighten saddle bolts evenly on both sides.  Avoid

over tightening.

3)   Using the opening in the drain outlet saddle as a

guide, drill ¼” hole in drain pipe.

4)   Install stem adaptor fitting.  Do not over tighten.
5)   Push union elbow fitting onto stem adaptor fitting and

connect drain tube.

              031177-002 (1/4” tubing)
It is recommended that all units have a shut-off valve
installed directly behind the unit.  This is a safety
precaution in case the unit needs to be shut off for
any reason.  It will also help in the filter replacement
and sanitation process.

NOTE:  All connections must conform to
applicable plumbing codes.
The Air Gap assembly may be installed anywhere
between the unit and the drain.  It must be installed
in a vertical position.  The inlet quick connect fitting is
for ¼” OD tubing and the outlet fitting connects to
3/8” OD tubing.

We recommend the use of DOW 111 exclusively
to lubricate o-rings on all OASIS

®

 components

and systems.  This silicone based FDA approved
lubricant has high viscosity, does not readily
evaporate at room temperature, and smoothly
adheres to the o-ring.  These qualities make
DOW 111 an easy to use long lasting lubricant.