Niles Audio Personal Emergency Reporting System PERS-3600B ユーザーズマニュアル

This Linear product is warranted against defects in material and workmanship for twelve 
(12) months. This warranty extends only to wholesale customers who buy direct from Linear 
or through Linear’s normal distribution channels. Linear does not warrant this product to 
consumers. Consumers should inquire from their selling dealer as to the nature of the 
dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear LLC 
for consequential damages arising out of or in connection with use or performance 
of this product or other indirect damages with respect to loss of property, revenue, or 
profi t, or cost of removal, installation, or reinstallation. All implied warranties, including 
implied warranties for merchantability and implied warranties for fi tness, are valid only until 
the warranty expires. This Linear LLC Warranty is in lieu of all other warranties express 
or implied.
All products returned for warranty service require a Return Product Authorization Number 
(RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other 
important details.

Linear radio controls provide a reliable communications link and fi ll an important need in 
portable wireless signaling. However, there are some limitations which must be observed.

•  For U.S. installations only: The radios are required to comply with FCC Rules and 

Regulations as Part 15 devices. As such, they have limited transmitter power and 
therefore limited range.

•  A receiver cannot respond to more than one transmitted signal at a time and may be 

blocked by radio signals that occur on or near their operating frequencies, regardless of 
code settings.

•  Changes or modifi cations to the device may void FCC compliance.

•  Infrequently used radio links should be tested regularly to protect against undetected 

interference or fault.

•  A general knowledge of radio and its vagaries should be gained prior to acting as a 

wholesale distributor or dealer, and these facts should be communicated to the ultimate 
users.

Copyright © 2008 Linear LLC 

228305 A

 

DX CODE 24-BIT A1D PPM  1,048,567 CODES

 

DXS CODE 24-BIT A1D PPM  1,048,567 CODES

 

PRIMARY SUPPLY  16 VAC 1.25 AMP PLUG-IN TRANSFORMER

 

BACKUP SUPPLY  12 VOLT 1.2 AMP/HOUR BATTERY

 

NORMAL OPERATING CURRENT  120 mA

 

ALARM OPERATING CURRENT  190 mA

 

BACKUP OPERATION DURATION  30 HOURS MINIMUM

 

BATTERY LIFE EXPECTED  3 YEARS

 

BACKUP SUPPLY OPERATING CURRENT  40 mA

 

BATTERY FUSE  1 AMP, TYPE 2AG

 RECEIVER 

TYPE 

DUAL-DIVERSITY 

SUPERHETERODYNE

 

RF SENSITIVITY  -100 dBm TYPICAL

 

RADIO FREQUENCY  315 Mhz

 

MAXIMUM RANGE  400 FEET LINE-OF-SIGHT, OPEN RANGE

 

  UL LISTED FOR 150 FEET

 

COMMUNICATOR FORMATS  4 BY 2 (GENERAL OR POINT-TO-POINT),

 

  ADEMCO CONTACT ID

 

  UL TESTED WITH SURGARD SGMLRG-DG

 

  CENTRAL STATION RECEIVER

CENTRAL STATION RECEIVER

 

DIALING  TONE OR PULSE

 

DIALING DELAY  0 OR 15 SECONDS

 

REMOTE PROGRAMMING PASSWORD  6 DIGITS

 

REMOTE COMMUNICATIONS PASSWORD  4 DIGITS

 

ACCOUNT NUMBER LENGTH  4 DIGITS

 

PRIMARY TELEPHONE NUMBER  20 DIGITS

 SECONDARY 

TELEPHONE 

NUMBER 

20 

DIGITS

 

SUPERVISORY TELEPHONE NUMBER  20 DIGITS

 

CONSOLE STATUS REPORT  OPTIONAL 1, 7 OR 30 DAY REPORT

 

OPERATING TEMPERATURE  32°-120° F (0-49° C)

 

HELP ALARM DURATION  1-30 MINUTES

 

ACTIVITY TIMER PERIOD  8, 12, OR 24 HOURS

 

AUDIO  LISTEN-ONLY, 2-WAY MANUAL, 2-WAY VOICE

 

  ACTIVATED (DUPLEX) SPEAKERPHONE

 

RELAY OUTPUT  N.O. @ 24 VOLT AC/DC 1 AMP

 

  MAXIMUM, NEC CLASS II CIRCUITRY

LIGHT CONCRETE

OR BRICK

65% - 95%

OF FULL POWER

10% - 70%

OF FULL POWER

CONCRETE WITH STEEL

REINFORCEMENT OR

METAL LATH AND PLASTER

WALLBOARD AND

WOOD STUDS

90% - 100%

OF FULL POWER

CENTRALLY LOCATE CONSOLE

TRANSMITTERS AT THE

OTHER END OF THE HOUSE

MIGHT BE TOO FAR AWAY

1 BEEP ................... TRANSMITTER ADDED TO A SENSOR ZONE

1 LONG BEEP ........ SENSOR ZONES FULL

2 BEEPS ................. CONSOLE IN STANDBY MODE, ACTIVITY TIMER ON

3 BEEPS ................. CONSOLE IN STANDBY MODE, ACTIVITY TIMER OFF

4 BEEPS ................. CONSOLE IN TEST MODE

5 BEEPS ................. CONSOLE IN LEARN TRANSMITTER MODE

6 BEEPS ................. CONSOLE HAS ERASED ALL TRANSMITTERS

7 BEEPS ................. PULSE DIALING HAS BEEN SELECTED FOR THE CONSOLE

8 BEEPS ................. TONE DIALING HAS BEEN SELECTED FOR THE CONSOLE

1. DIAL THE NUMBER OF THE PHONE LINE THAT THE CONSOLE IS CONNECTED TO, 

ALLOW IT TO RING THREE TIMES, THEN HANG UP

2. WAIT ABOUT 10 SECONDS, THEN CALL THE CONSOLE A SECOND TIME

3. WHEN THE CONSOLE ANSWERS, A TONE WILL SOUND FOR ABOUT 8 SECONDS

4. WHEN THE TONE ENDS, ENTER THE REMOTE AUDIO PASSWORD (DEFAULT 1234) 

FOLLOWED BY THE # KEY

  THE CONSOLE WILL BEGIN AUDIO COMMUNICATIONS (2-WAY DUPLEX, 2-WAY MANUAL, 

  SEE SECTION 16 FOR AUDIO COMMUNICATION OPERATION DETAILS

  NOTE: IF THE CONSOLE AUDIO IS SET TO “NONE” REMOTE AUDIO COMMUNICATIONS