Honeywell Excell 500/600 Controll System 500-XCL5010 ユーザーズマニュアル

EXCEL 500/600 INSTALLATION INSTRUCTIONS

NOTE: The CPU modules XC5010C and XCL5010 do not

contain a battery. RAM is buffered for 3 days by a
capacitor.

Dismantling the Control Panel Unit

Before dismantling the controller, the low voltage switch S1 of
the power supply module must be switched OFF (position 0).

To dismantle the control panel unit, reverse the steps of the
installation procedure (see page 8). To release the locking
screws in order to remove the wiring base, turn them clock
wise as shown in Fig. 40.

Fig. 40. Releasing housing locking screws

Dismantling the Control Panel Door Unit

Before dismantling the system, disconnect the power supply.
To dismantle the control panel unit, reverse the steps of the
installation procedure (see page 10).

Dismantling the Housing Cover

1. Release the metal retaining clamp.

Fig. 41. Housing cover retaining clamp

2. Pull off the cover.

Dismantling the Excel 500-XCL5010 Control

Panel Unit

Before dismantling the system, disconnect the power supply
(e.g. by removing the terminal block or by an additional 3

party switch which should be installed onto the DIN rail close
to the controller; see also warnings and notes in section
"Electrical Connections" on page 20).

CAUTION

Always plug in the communication module before
connecting the power supply.
Always disconnect the power supply before
unplugging the Communication module.

EN1R-1047GE51 R0902