Moog Music Recording Equipment MF-105 ユーザーズマニュアル
GETTING STARTED
Here are some simple instructions on how to quickly plug in and
try out your MF-105.
1. Unpack your MF-105. Place it on a table while you become
familiar with its features.
2. Check that the power adaptor has a nominal rating of +9 volts,
providing at least 300 mA (milliamperes) of current and is also
rated at your country’s standard power voltage (120 volts A.C. for
the United States and Canada; 100 volts A.C. for Japan; and 220
volts A.C. for most other countries). Plug the power adaptor’s cord
into the MF-105’s ‘+9V’ jack. Then plug the power adaptor itself
into a power voltage receptacle. Note the MuRF uses a different
power supply than other moogerfoogers, which is only rated at
200mA. Using a 200mA moogerfooger power supply may result
in hum, distortion, and other less than desirable audio artifacts.
Make sure to use the proper power supply.
3. Note that the BYPASS light is on. It will light up either red or
green. Red indicates that the MF-105’s effect is off-line (bypassed),
while green indicates that
the effect is on. Pressing the
‘stomp switch’ will toggle the
BYPASS light between red
and green. For now, leave the
BYPASS light on red.
Refer to Figure 1 for steps 4.
and 5.
Figure 1 - Basic Connections to MuRF