Eaton Electrical Wireless Office Headset SC200 ユーザーズマニュアル
Connecting the Battery Cables (if applicable)
Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.
IPN 997-00012-41D December 2006
3-9
Step 1 - Prepare cable clamp
Cut off the two inside posts of the battery cable clamp to enable the battery
cables and sleeve to fit.
cables and sleeve to fit.
Step 2 – Strip cable and fit sleeve
Strip approximately 17mm (
3
/
4
”) of the insulation from the cable ends. We
recommend fitting cable ferrules over the cable ends.
Feed both battery cables through the 16mm sleeve.
Step 3 – Terminate cable
Terminate
the
positive battery cable at the Battery (+) terminal block.
Terminate the negative battery cable at the Battery (-) terminal block.
Tighten the terminal screws. Required torque: 2.5 - 3 Nm (22.1 – 26.5 lb-in).
Ensure that the polarity at the battery terminal blocks matches the polarity of the
external battery. Connecting a reverse polarity battery to a power system will cause
damage to the rectifier modules. Such damage may not be covered by the warranty.
"
16mm battery cable sleeve.
#
Battery cable clamp with posts removed.
Step 4 – Arrange sleeve and clamp the battery cables
Arrange the cable sleeve so that it is within 10mm (
3
/
8
”) of the terminals.
Tighten the cable clamp screws. Required torque: 1.5 – 2 Nm (13.2 – 17.7 lb-in).