ASA Electronics Voyager AOM701 ユーザーズマニュアル

This control toggles the active display image back and forth between AV1 and 
AV2 inputs. AV1 is the default source for the Blue Standby trigger wire.

 
3.  Day/Night Mode Button

This control toggles the unit between “Day” and “Night” LCD illumination 
modes.  In the “Day” mode, the LCD backlight intensity is at maximum.  In 
“Night” mode, the LCD backlight is dimmed to a preset level that is more 
suitable for low light operation.

This control accesses an On-Screen-Display (OSD) menu for four LCD picture 
adjustments (Brightness, Contrast, Color, and Tint).  The first depress of the 
button accesses the “Brightness” adjustment.  The Volume +/- controls adjust 
the level, which is indicated by the bar graph at the bottom of the screen.  Each 
consecutive depress of the Picture button accesses the adjustment screen for 
each picture adjustment.  If no buttons are pressed within 6 seconds or controls 
other than the Picture and Volume buttons are pressed, the unit will exit the 
Picture Adjustment mode.

This 2-button set of controls adjusts the output volume of the built-in audio 
speaker when the audio function is enabled *(see typical system connection 
diagram).  The “+” button increases output volume.  The “-” button decreases 
output volume.  Volume level is indicated by the OSD bar graph at the bottom 
of the screen.

These buttons also serve as adjustment controls while in the Picture Adjustment 
Menu mode (see above section for details).

*Note: The AOM701 requires +12V to be applied to the “Audio Enable” trigger 
input in order to activate the built-in speaker.  If no audio output is heard from the 
speaker regardless of the volume level adjustment, check this connection.

5