Meridian Data SecurStor iSCSI to SATA-II RAID Subsystem 16i ユーザーズマニュアル
B-1
Appendix B
Pinouts
B.1. D-SUB 9 and Audio Jack Pinouts
B.1.1. COM1 Serial Port Cable
COM1 Cable: This cable connects the COM1 serial port on the controller module to the serial
port of a management computer. The serial port’s defaults and requirements are:
1. Set at 38400 baud, 8 bit, 1 stop bit, and no parity.
2. In most cases, connecting RD, TD, and SG is enough to establish communications with a
terminal.
Figure C-19: Adapter Cable for COM1 - Connector Pinouts
CN1 Pin Number Pin Name
1 Ground
2 TXD
3 RXD
CN2 Pin Number Pin Name
1 NC
2 RXD
3 TXD
4 DTR
(Shorted)
5 GND
6 DSR
(Shorted)
7 RTS
(Shorted)
8 CTS
(Shorted)
9 NC
Table B-1: COM1 Adapter Cable CN1 and CN2
Pin Out Definitions