Tower Hobbies Motorized Toy Car ST-15 ユーザーズマニュアル
❍ 3. Remove the antenna tube from the parts bag. Run the anten-
na through your fingers a few more times to straighten the receiv-
er antenna wire. Thread the receiver antenna wire through the
antenna tube. Press fit the antenna tube into the antenna holder
which is located on the throttle servo mount. Do not cut or coil
the receiver antenna wire.
na through your fingers a few more times to straighten the receiv-
er antenna wire. Thread the receiver antenna wire through the
antenna tube. Press fit the antenna tube into the antenna holder
which is located on the throttle servo mount. Do not cut or coil
the receiver antenna wire.
❍ 4. Remove the air filter from the parts bag. Remove the 3 air
filter elements from the air filter housing and soak the air filter
elements with air filter oil (not included) and then squeeze the
excess oil from the elements. A light shock oil may be used or you
can purchase special air filter oil from most hobby shops. Place
the air filter elements back into the air filter housing, and then
install the air filter assembly onto the top of the carburetor.
filter elements from the air filter housing and soak the air filter
elements with air filter oil (not included) and then squeeze the
excess oil from the elements. A light shock oil may be used or you
can purchase special air filter oil from most hobby shops. Place
the air filter elements back into the air filter housing, and then
install the air filter assembly onto the top of the carburetor.
❍ 5. Remove the two 3x10mm screws from the receiver battery
case which is located on the rear of the truck. Then remove the
cover from the top of the receiver battery case.
case which is located on the rear of the truck. Then remove the
cover from the top of the receiver battery case.
❍ 6. Remove the receiver battery holder from the receiver battery
case. Install 4 (included) "AA" batteries into the battery holder in
the configuration molded into the battery holder. Re-install the
battery holder and the battery case top with the two 3x10mm
screws which you removed earlier.
case. Install 4 (included) "AA" batteries into the battery holder in
the configuration molded into the battery holder. Re-install the
battery holder and the battery case top with the two 3x10mm
screws which you removed earlier.
❍ 7. Remove the transmitter antenna from the parts bag and
install it into the top of the transmitter as shown. To ensure that
the antenna is attached, lightly pull on the antenna. If it slides out,
it is not screwed in properly.
install it into the top of the transmitter as shown. To ensure that
the antenna is attached, lightly pull on the antenna. If it slides out,
it is not screwed in properly.