Dyson Airblade Tap オーナーマニュアル

THANK YOU FOR CHOOSING TO BUY

A DYSON AIRBLADE TAP HAND DRYER
DYSON CUSTOmER CARE

Your hand dryer is covered for 5 years from the date of purchase, subject to the terms

of the limited guarantee.

If you have any questions about your hand dryer, call the Dyson Helpline at

1-888-DYSON-AB with your serial number and details of where and when you

bought the unit.

Note your serial number here for future reference.

Your serial number can be found on the bottom right hand corner of the backplate,

on a registration sheet in the box, and also on the large information sticker which can

be found around the tap when the unit is unpacked.

This illustration is for example purposes only.

WARNING

A comprehensive installation guide is enclosed with the hand dryer packaging. This

contains detailed information on the correct installation of the unit, which MUST be

adhered to completely, including routing of electrical cables. Damage caused by

incorrect installation is not covered by your warranty. Dyson recommends a 15 amp

circuit breaker with a dedicated line and neutral. Contact a qualified electrician

and plumber to determine the specific requirements for your particular installation.

Installation work and electrical wiring MUST be done by a qualified electrician and

plumber in accordance with all applicable laws, codes, and standards.

The instructions in this manual and the installation guide must be followed completely,

as failure to do so may result in incorrect operation, damage to property and/or

personal injury. It is recommended that an isolation valve is fitted with this product

during installation.

Dyson will not be held liable for any damage to property or personal injury, or any

loss of business or revenue, if you, your staff, your installer or service engineers have

not followed the instructions given in this manual and the installation guide.

ImPORTANT SAFETY INSTRUCTIONS

BEFORE INSTALLING OR USING THIS UNIT READ ALL INSTRUCTIONS

AND CAUTIONARY mARKINGS IN THIS mANUAL AND THE

INSTALLATION GUIDE

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

1. This unit is not intended for use by persons (including children) with reduced

physical, sensory or reasoning capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction concerning use of the unit

by a person responsible for their safety.

2. Do not allow the unit to be used for any purpose other than washing and drying

hands. Use this unit only in the manner intended by the manufacturer. If you have

questions, contact the manufacturer.

3. Before servicing, switch the power off at the service panel. Ensure the switch is

locked to prevent the power from being switched on accidentally. If the means of

switching off the power cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

4. Children should be supervised to ensure that they do not play with the unit.

DO NOT USE ANY PRESSURE WASHING EQUIPmENT FOR CLEANING

ON OR NEAR THIS UNIT.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS

APPLIANCE WITH ANY SOLID-STATE SPEED CONTROL DEVICE

WARNING: RISK OF ELECTRIC SHOCK!

All electrical repair work must be done by qualified electrician(s) or Dyson Service

Engineers in accordance with all federal, state and local laws and applicable

codes and standards, including fire-rated construction. If casing is removed or

handled improperly the internal components of the unit may cause harm or

become permanently damaged.

CAUTION

Your hand dryer should be located indoors. Operating temperature range

32°F (0°C) to 104°F (40°C). To reduce the risk of fire or electric shock, do not

expose the internal mechanisms/components of this unit to moisture.