BENDIX TCH-005-008 プリント
INSTALLATION (Ref. Figure 1)
1. Install the replacement slack adjuster on the camshaft.
2. Run the push rod locknut on the push rod approximately 1-1/2 in., place the flat
washer in position and thread the push rod adapter onto the push rod so that
approximately 1/8 in. of the push rod is showing.
approximately 1/8 in. of the push rod is showing.
3. Turn the external manual adjustment until the push rod adapter slides into the yoke
body so that the retainer holes in the yoke body are aligned with the groove in the
adapter.
adapter.
4. Install the hair pin retainer in the holes and bend the ends over.
5. Tighten the push rod locknut against the flat washer. Torque locknut as follows:
1/2 - 20 push rod – 300-400 in. lbs.
5/8 - 18 push rod – 400-600 in. lbs.
5/8 - 18 push rod – 400-600 in. lbs.
6. MANUALLY ADJUST BRAKES.
NOTE: For further information, refer to Service Data Sheet SD-05-2.
CATALOG INFORMATION (Ref. Catalog Page 05-A-18)
The following slack adjusters, listed on catalog page 05-A-18, incorporate the quick
connect yoke assembly.
The following slack adjusters, listed on catalog page 05-A-18, incorporate the quick
connect yoke assembly.
Automatic slack adjusters with the quick connect yoke assembly are not furnished with
the adapter, retainer and washer. These items must be purchased separately.
the adapter, retainer and washer. These items must be purchased separately.