Honeywell HEGS5001 ユーザーズマニュアル

Master Default Password is 1994. 

Operator Default Password is 1111. 

Master mode has access to all menus.  Operator mode allows access to all menus 
except those in which changes to system setup are involved.  The table below shows 
which menus and functions are available for each mode. 

Save PreShot - KD6/HD6 domes 

1-10 Only 

Yes 

Recall PreShot on KD6/HD6 domes 

Yes 

Yes 

Programming a VectorScan - KD6/HD6 domes 

No 

Yes 

Running a programmed VectorScan – KD6/HD6 
dome 

Yes Yes 

Programming a tour menu – KD6/HD6 dome  

No 

Yes 

Running a tour – KD6/HD6 dome  

Yes 

Yes 

NightShot On/Off –KD6/HD6 

Yes 

Yes 

Auto iris on/off – KD6/HD6  

Yes 

Yes 

Programming a sector – KD6/HD6  

No 

Yes 

Programming a privacy zone – KD6/HD6  

No 

Yes 

Access to the KD6/HD6 dome setup menu  

No 

Yes 

Access to the System Setup Menu 

No 

Yes 

Access to the multiplexer setup menu 

No 

Yes 

To return the controller to the user-defined default settings, perform the following steps. 

1.  Power the unit down and back up.   

2.  When the LCD display shows the controller is Booting Run Menu key during the 5-

second booting process.  

<Spot01

Cam001>

 

 

In the above display, the HEGS5000 is configured for MUX mode of operation.  Spot01 
is the Spot Monitor and Multiplexer the controller is currently controlling.  This will 

change if you have more than one multiplexer in your system.  Spot 01 is the spot 
monitor for multiplexer one; Spot 02 is the spot monitor for multiplexer two, etc.  Refer to 
section 6 for MUX operation. 

Cam001 is the camera currently being controlled.   

If the controller is configured for Standalone mode of operation; the Spot monitor is not 
displayed. 

Rev. 1.01 

11 900.0800 

  

19-Jun-06