Honeywell HEGS5001 ユーザーズマニュアル
5.2.5 Programming a VectorScan
Note: VectorScan Programming is only available to Master users.
1. Press
the
Dome Menu (
1. ___
3. ___
) key.
2. Press
the
+ or – key until VectorScan Menu is displayed.
3. Press
the
Enter (
) key.
5. Press
the
+ or – key until Program is displayed.
6. Press
the
Enter (
) key. Follow the on-screen prompts that appear on the monitor
where the KD6/HD6 video is viewed.
A
< Select Function >
7. Enter the VectorScan number (0-9) using the numeric keypad and press the Enter
(
) key. If the selected VectorScan# has already been programmed the title is
displayed and the programmed PreShots are displayed. To accept the existing title,
press Enter (
). To change the current title proceed to step 8.
8. Enter the desired title by performing the following steps.
a. Press
the
+ or – key until the desired character is displayed on the LCD screen,
and then press Character Select (
ABC
). The controller sends the character to
the KD6/HD6.
b. Continue selecting characters and press Character Select (
ABC
) until the
desired title is displayed on the monitor.
c. Press
Enter (
). The cursor moves to the first PreShot field.
9. Enter the first PreShot Number (0-99) using the numeric keys. Note: If the cursor
doesn’t automatically move to the Velocity field, press the right arrow key () below
the controller’s LCD.
the controller’s LCD.
10. Enter the velocity from 1 to 400 (degrees per second) in the VELOCITY column of
the 0 row. If the cursor doesn’t automatically move to the Velocity field, press the
right arrow key () below the controller’s LCD.
right arrow key () below the controller’s LCD.
11. Type the dwell time from 0-99 seconds.
12. Continue entering PreShots (up to a total of 64) by repeating steps 9, 10, and 11.
Rev. 1.01
30 900.0800
19-Jun-06