BENDIX TCH-013-024 プリント
Technical
Bulletin
Bulletin No: TCH-013-024
Effective Date: October 25, 2013 Cancels: NA
Page: 1 of 2
Subject:
Bendix
®
TABS-6
™
Advanced Single-Channel Trailer ABS: Troubleshooting
“Internal Lateral Acceleration Sensor - Mounting Error” Diagnostic Trouble Codes
The purpose of this Bulletin is to assist technicians
when troubleshooting Bendix
®
TABS‑6
™
Advanced
single‑channel trailer ABS modules, where an “Internal
Lateral Acceleration Sensor ‑ Mounting Error” (internal
code 14D00, or SID‑FMI 99‑14, or blink code 8‑1), is
causing an illuminated trailer ABS lamp.
P/Ns K027233, K029053, K027235, K032041, K032042,
K027241, K035805, K032108, K041383, and K065528.
This Bulletin covers the potential causes for this DTC.
A1. Check the orientation of the Electronic
Control Unit (ECU) installation.
Each Bendix TABS‑6 Advanced ECU comes
preconfigured for a certain orientation. Use the Bendix
®
ACom
®
Diagnostics software [free software downloads
are available at www.bendix.com] to view the current
configured orientation of the ECU on the Controller
Configuration screen. Then use Figure 1 below to verify
if the TABS‑6 Advanced ECU is installed as configured.
• If the configuration matches, go to B.
• If the configuration matches, go to B.
A2. If the configured orientation does not match the
physical orientation, use the Bendix ACom diagnostic
software to:
• change the configured orientation to match the
• change the configured orientation to match the
installation;
• verify that the speed sensors are installed correctly
for this configured orientation (see Figure 1); and
• perform an End‑of‑Line Test (EOL Test) using the
software or a Bendix
®
Trailer Information Module
™
.
Recheck for any remaining DTCs and return the vehicle
to service.
B. Check if the wheel speed sensors ‘SC’ and
B. Check if the wheel speed sensors ‘SC’ and
‘SD’ are swapped
This DTC is caused by the ECU comparing the
difference in wheel speed readings between the left
and right wheel speed sensors to cross‑check with the
on‑board lateral accelerometer. Reversed sensors can
cause a DTC to falsely trigger. Wheel speed sensors
‘SC’ and ‘SD’ locations are ECU‑orientation specific
(See Figure 1).
TA
BS
AD
V
V
TABS
ADV
TA
BS
AD
V
TABS
ADV
RIGHT - “CURB SIDE”
FIGURE 1 - BENDIX
®
TABS-6
™
ADV MODULE ORIENTATION & WHEEL SPEED SENSOR LOCATIONS
LEFT - “ROAD SIDE”