West Elm Metal Picture Ledge 組み立て手順

page 1 of 1

mounting instructions

9775941/9775958/9775966- 09/07

: metal picture ledge

NOTE:

•     Stud mounting is recommended. Use proper hardware
       for your wall type (such as anchors for drywall). When
       in doubt, consult your local hardware store. For your
       safety, installation by two people is recommended.

• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.

• Maximum load for 2’ shelf : 20 lbs.

• Maximum load for 3’ and 4’ shelves : 40 lbs.

drywall anchor 2x - 2’

3x - 3’ and 4’

screw 2x - 2’

3x - 3’ and 4’

1.    Hold shelf at desired location. Use a carpenter's level to ensure the
       shelf will be level. With a pencil, mark through the top of the
       mounting holes. These marks are the insertion points of the mounting
       hardware.

2.    For stud mounting: skip to step 3. For drywall mounting: using a
       Phillips head screwdriver, insert the drywall anchors (A) into the
       wall at the insertion points. Press and turn clockwise until anchors
       are flush with the wall.

3. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/2" between the back of the screw head and the wall.

4. Align keyhole notches over the screw heads.

5. Slide the shelf down until it rests on the screws. Tighten or loosen
screws as needed to fit the shelf snugly against the wall.

For drywall mounting, use anchors with screws.

For stud mounting, use screws only.