Brother P-touch PT-2700 クイック設定ガイド

Creating a Bar Code Label

Using the Bar Code function you can create labels with one dimensional bar codes for 
use with cash registers, stock control systems or other bar code reader systems, or 
even asset control tags used in an asset management system.

Press the 

 key to display the Setup menu, select 

“Bar Code Setup” using the   or   keys, and then 
press the 

 or   key.

The Bar Code Setup screen is displayed.

Select an attribute using the   or   keys, and then 
set a value for that attribute using the   or   keys.

Press the 

 or   key to apply the settings.

• The P-touch labeler is not designed exclusively for creating bar code labels. Always check that 

bar code labels can be read by the bar code reader.

• For best results, print bar code labels in black ink on white tape. Some bar code readers may 

not be able to read bar code labels created using colored tape or ink.

• Use the “Large” setting for “Width” whenever possible. Some bar code readers may not be 

able to read bar code labels created using the “Small” setting.

• Continuously printing a large number of labels with bar codes can overheat the print head, 

which may effect printing quality.

Pressing 

 key while holding down 

 key will 

also allow you to go to  "Bar Code Setup".

The "C-Digit" (Check Digit) attribute is only available 

for the CODE39, I-2/5 and CODABAR protocols.

Characters may not appear below the bar code even 

when "On" is selected for "Under #", depending on the 

tape width being used, the number of lines entered, or 

the current character style settings.

New settings are NOT applied if you do not press the 

 or   key.

• Press the 

 key to return to the previous step.

• Press the 

 key to set the selected attribute to the default value.

• Refer to the Bar Code Settings table for a list of all available settings.